Search:
Type: Posts; User: jmc1324
Search:
Search took 0.00 seconds.
-
I have a 97 Olds Aurora that the heater blower doesn't turn on, Checked the fuse that I could side of dash and under rear seat, is there any other fuses? Fuse block cover in engine compartment but...
-
21 boat you are correct and I forgot my "," as for the hot tub placement 2 days should be OK "," but to drive on at least one week
When I need to drive on sooner than a week I use 4500 psi...
-
For a hot tub as frank said above 2 days should be OK to drive on at least a week, as for the 3000 psi why? I usually won't pour anything less the 4000 psi sidewalks patios floors or driveways, 3000...
-
I have a 1997 Oldsmobile Aurora that the front door will not unlock or open. Use door all the time closed door drove about 10 miles to store upon arrival the drivers door would not open. Any ideas??...
-
Pressure treated wood should not be painted, wait at least 6 months and STAIN
-
Neighbor has a 5 yr old Husqvarna riding mower runs great lots of power when traveling as soon as blades engaged no power any ideas where to start?? I think its and 18 hp automatic
-
As for CODE: if built before the IRC code and only doing for personal energy savings any amount of insulation is better than none I do a lot of remodeling even though I would like to see the most...
-
21 boat
If you take the standard 34 1/2" base cabinet 1 1/2" for counter top 18' space that equals 54" you can install 30" - 42" upper cabinets with an 8' ceiling height. 54" + 42" = 96"
With a...
-
When I install upper cabinets the bottom of the uppers are in stalled 54" above finished flooring, as for stove hood each hood has it's install height usually about the same they work best if...
-
in PGH PA the average is about $1.50 a square ft. that buy hang and finish if whole house a 4 x 12 sheet will cost you $72 a sheet... that's the sheet rock, mud tape and labor
smaller the job...
-
I use and stain pine a lot and sounds as if too long a period was left before wiping off or too many pieces were stained at one time, the easiest way to go about evening out the blotchyness is to...
-
WOW Jim that's a loaded question where to start?
First will your existing roof be able to accept and carry the weight of a secondary framed roof over it? What type of existing roof framing is...
-
Leave your door open after using if you close the door after using it will never dryout inside and mold will grow around the rubber gasket at the door... clean the rubber gasket then run a cycle of...
-
Thanks Captain Rich Changed the compressor with a used one Cheaper and faster than changing just the clutch with reman unit works great
-
As we all said BAD PREP WORK after seeing the pictures and there are no expansion joint. WOW!! I'd be all over this contractor to replace at his cost. Also since the crack is about a foot away from...
-
You will be OK until you re-roof as long as you have no leaks, as for 15# or 30# felt / tap paper I always recommend 30 # it protects your house from weather while roof is being replaced in case of...
-
From start to finish unless special orders / or weather hold up progress 6 months max from site prep to moving
-
what type of load will be above if just supporting ceiling dry wall you'd be OK with just 2 x 8 if having a room above for living space I would go with the "I joist system"
-
From what you are describing sounds as if bad prep work was done either very little or no sub base used, rule of thumb for every inch of concrete you need that much gravel sub base, 4" concrete 4"...
-
I have a 2001 dodge ram 1500 that the system is full of freon but the compressor won't engage, we jumped the low and high pressure switches with no luck, checked fuse and relay both OK..
|