Search:
Type: Posts; User: jam1
Search:
Search took 0.00 seconds.
-
I understand why the two poles or breakers need to be on separate bus bars or "Phases", and how the neutral will take the difference. And I understand how if the two hot wires are not on separate bus...
-
I want to run 8 new circuits, four 15 amp and four 20amp. Each can be paired with a beginning run of a 14/ 3 or 12/3 wire from the breaker box to a junction box and then can be split off so that a...
-
I would like to add that in going around the house and checking many of the lamps with metal casings, they almost all set the detector off. So either there is a house wide problem or it is not a...
-
I am going to change the wire feeding the lamp to a new 14 gage run between the switch and the lamp. But before doing that, I temporarily put up a new lamp on the old wire and its case does not seem...
-
My mother is attached to a hard sought and found outside wall mount lamp above her garage. The metal lamp case sets off my current indicator as much as 110-120 volts do. I knew we have touched it in...
-
4 electricians gave estimates to upgrade a service box from 100 to 200 amps. Only one felt that the new panel should definitely be moved because the old one is smaller and sits up against the gas...
-
What happens theoretically to a receptacle when the hot and neut wires are hooked up to the reverse screws?
This is a question about the anatamy of a non GFCI receptacle. Besides the difference...
-
I have an open unfinished basement with a 20 amp circuit which supplies only a junktion box. It used to have a pull light on it. I have continued the 12 gage wire, which entered the junction box...
-
We paid, in good faith--and stupidity--, a contractor who promised that he would correct a leaking gutter he just put up and which he saw leaking and admitted was improperly constructed. Furthermore...
-
A plumber left us mid way through with only two copper hot and cold water lines coming up through the floor and cabinet. I want to finish the job and attach turn off valves and lines to the...
-
I have done a bit of electrical work installing lighting and outlets and running new service to new appliances. I need to upgrade an old electrical breaker box from 100 amp to 200 amp. I want to know...
-
What is the proper step by step procedure from shutting off gas to turning it back on when installing a shut off valve to the stove gas line? When one shuts off the main gas do I need to wait any...
-
How do I properly attach the flex pipe to the gas stove on one end and the supply pipe on the other end? Do I need a gas poxy? If so what is the proper method of application--on both sides of the...
|