Ask Experts Questions for FREE Help !
Ask

Search:

Type: Posts; User: jsjmax

Search: Search took 0.00 seconds.

  1. The controls are operated on vaccumm, When you...

    The controls are operated on vaccumm, When you accelerate the vaccumm(sp)drops and the blend door starts to go back to the off position. When you let up the vac comes back and puts it where the...
  2. There is a good chance the chip in the key has...

    There is a good chance the chip in the key has gone bad. Try the spare
  3. Answers
    2
    Views
    1,117

    It sounds like either you have a bad idler gear...

    It sounds like either you have a bad idler gear or syncro inside the transmission. Also have you checked the fluid level in it? Need A good transmission man to either rebuild or replace the unit....
  4. Answers
    2
    Views
    2,173

    If it has a single coil it could be the resistor...

    If it has a single coil it could be the resistor inside is bad. One way to check this is to hold the key in the start position after it starts. If it continues to run it is most likely that....
  5. Answers
    2
    Views
    420

    It is best to store them in the upright position...

    It is best to store them in the upright position in a dry dark location.Basements are great for this. If you stack them for ant period they will flatten out making them harder to mount.
  6. I would also check the fuel pressure, The fuel...

    I would also check the fuel pressure, The fuel pump or relay could have gone bad.
  7. Question: Short in van

    by jsjmax
    Answers
    4
    Views
    702

    Has the van been in salty conditions? Road salt...

    Has the van been in salty conditions? Road salt etc? Sounds like the fuse block under the hood on the drivers side. Usually the wires rot off on the back and need to be rewired with new terminals. If...
  8. Answers
    0
    Views
    815

    ford 6.0l shut down hot, no restart

    04 F350 4X4 6.0l diesel. Pulling a trailer up hill running fine. Got to the top and shut down would restart and run for about 5 seconds and shut down again. Ck with scanner and got code for crank/cam...
Results 1 to 8 of 8