Search:
Type: Posts; User: kanrdc
Search:
Search took 0.00 seconds.
-
Emma.
Take care of yourself because he sure isn't. 20 yrs old and soooo much to give. I say find someone else to give it to baby. Good luck
-
Not the impeller but the inducer. The inducer is the motor that pushes the exhaust out to the chimney. Try cleaning the flame sensing rod which is located in front of the far left hand burner. It is...
-
Very carefully try to clean out the pilot assembly. You may have built up some spent carbon all along the surface to the pilot oriface. Take some steel wool or sand paper to the spark rod and pilot...
-
Check your filter. High suction line temps are usually caused by air restriction across the coil. Try taking the filter out for a couple of minutes and see what happens. You will be amazed. After you...
-
If you haven't solved the problem: Goodman/Janitrol is notorious for losing pressure around the gasket of the inducer housing. You can try removing the 5 screws that hold on the inducer motor housing...
-
Need more info to help you. Make, Model, 90% or conventional venting, standing pilot or electronic ignition? First guess is cooler air is condensating your electronic ignition down your flue pipe....
-
Installing a new heat pump in colder temperatures is very challenging. The refrigerant should be weighed in to get accurate levels. Set points are the trickiest part of balancing your system. Your...
-
Always provide yourself with a way to shut off the water if something goes wrong. At our company we always put the saddle valve after the last gate or ball valve. Good luck
-
Two things are possible: there is a flame sensing rod in front of the far left hand burner. Take a piece of steel wool and GENTLY clean it off by sanding the rod up and down. This sensing rod tends...
-
Your pilot is either too weak or not surrounding the thermocouple enough. Direct consistent flame is all that will keep the thermocouple sending its signal to the gas valve. Try adjusting the...
-
Try taking the pilot tube off the gas valve and blowing through it. You may have gotten some debris in the pilot tube causing obstruction. Question: is there a regulator on you lp tank? If so was it...
-
How do I wire a humdifier into a space pak system without bringing on the condensing
|