Search:
Type: Posts; User: Better life
Search:
Search took 0.00 seconds.
-
The string doesn't rewind into the house after I pulled to start the engine, the engine could start. How can I rewind the it in?
-
Thanks Guys. I opened the back panel, found the fan stopped running and the ice built up blocking the air way to the refrigerator, I cleared the ice and spinned the fan. It works now.
-
Hello all. My refrigerator is ESTATE model TT184KXDW00. I found the refrigerator is not cold at all but the freezer is working. Please advise what I could do. Many Thanks!
-
I will take pictures.
I pressed on the relay, it didn't stay. Even later it stayed, the fan had to wait till something clicks inside a box under the tranformer.
-
I also noted that the green light on the circuit board in the heatpump was blinking. Does this tell any thing?
-
Finally, I got a chance to test it. I set the thermostat to fan on, there is no blowing while the heatpump runs. I then twisted the red and green wires together then turned the power on, the heatpump...
-
Do you give up helping me?
-
I tried to search the posts with pictures to check the air handler but I did not find.
Please advise how to check the air handler.
-
I don't see the terminals of "C" and "O" on the heatpump. I also found that the pipes going out from the unit to the wall are icy after I turned the cooling system on. The ice was melt after I turned...
-
Thanks and I let you know the result.
-
I have a volt meter. So I will put the red and black needles on both "O" and "C" without turning off the power, am I right?
Or without volt meter, I will take off the outer panel on the heat pump...
-
My cooling system is not blowing cold air, is it suppose to blow like heating system? The heat pump runs on both systems.
-
Should I jump from Aux to E?
-
I did setup the function 0170 to number 7 as Multi-stage heat pump: Heat pump with backup or auxiliary heating.
I also did setup the function 0190 to number 0 as Cooking changeover valve: Use this...
-
I raised the temp to 80, the heat air blows and raised the inside temp to 76 with Aux Heat On. I stopped the heating system.
Now I am trying the cooling system, I set the temp to 66 degrees,...
-
I eventually installed the thermostat as instructed. Tried it by raising the temp 2 degrees to 77 degrees, heat pump runs, heat air blows, but screen shows Aux heat on. This is not what I expected, I...
-
Hello all experts: I recenty bought a new Honeywell thermostat to replace my old GE thermostat. How do I connect the wires? My heating system is using heatpump with multistage. Thanks a bunch! Ben
|