Search:
Type: Posts; User: dno36
Search:
Search took 0.00 seconds.
-
Greetings,
I live on the bottom floor of a 45-year old, 16 unit 4-story condo.
I have had no other drain issues at all, ever... until I bought a washer.
The unit had a space for a stackable...
-
OK... found my problem.
It was not the drain box.
About 3 hours after I pulled the top hose, the house had warmed to 66... however, the main blower was running, but there was no heat and the...
-
OK... what's the answer Cowgirl?
-
GREAT POST!
Just saved me in NE IL... it is -16F today and my furnace did the same thing.
Was able to restart by pulling the upper hose and get my heat back on.
I will check the drain when...
-
bluewrench... what has occurred from this?
I have had a similar issues and may be able to assist.
Dean.
-
Which wire would the ground be off the solenoid?
I used jumper cables and hooked the ground to the battery ground and then to the mount bolt on the solenoid. That is all I could figure for a safe...
-
OK 21, I have gone right down the line with your suggestions today.
1. Cable are fine, I am a bit obsessive about them. It starts fine across the solenoid as well.
2. The switch is new, and...
-
OK, I finally had a chance to dig into the starting issuetoday.
I did the negative jumper as above, to both mounting bolts and even tried to contact the bottom of the solenoid itself, and nothing...
-
Greetings 21boat, and thanks for the answer!
I will post back as I go here with all the suggestions tried.
Thanks
Dean.
-
Best idea I've heard in, well, 2 years.
I will try it by the end of the week and post back.
Thank You
Dean.
-
Greetings,
I have a JD Sabre 1546G with a briggs engine and have had a wicked time solving my no-starting/turnover issue. Going on 2 years of frustration.
1. I have already replaced both the...
-
If you do not have an answer yet, I just figured this out by viewing another similar tractor and taking pics.
I can send you pics of the routing if needed.
Dean
-
Tkr:
The welder is a Miller Maxstar 150
It has the following info:
Duty Cycle Rating: 230 VAC TIG 100 amps @ 14 Volts-100%
Amperage Draw at the above rating 8.3 amps
Hope this is what...
-
Greetings all,
I have a small dual voltage welder 150 amp output @ 220v, 90 amp @ 110v, that I have used as a portable for a number of years. It is a great welder.
When I got it, I had it...
-
There should be a plastic cap covering a spring clip over the end of the axle.
Once the clip is off the wheel should slide right off the axle.
There is a groove in the wheel that matches the long...
|