Hello! I am having a little trouble with a submersible pump. It pressures up to 28 pounds (it should pressure to 50 pounds) and then it just sets there. Can't seem to get any more pressure but the switch doesn't seem to be doing anything after it reaches the 28 pounds. I have watched it and I can't see that it is shutting off once it reaches 28 pounds but it does hold that pressure unless you open a valve in the house. I was wondering if it could be a leak in the bladder of the pressure tank causing this although as I said I can't see that the switch is actually shuting off.. The pump is way down in the well so all I have to go by is the pressure valve and it doesn't indicated that the pump is shutting off.

I thank you for your time and information

Hoodoo

labman

It really sounds to me like a worn impeller in the pump, but that wouldn't have happened all the sudden. Usually there is vibration in the pipe when the pump is running. Does it continue after reaching the 28 psi? You have noticed reduced water flow, not just a faulty gage? The one thing I can think of is a cracked pipe, that allows more water out as the pressure goes up, with the leak matching the pump at 28 psi. Bad news if it is in the well and the pipe supporting the pump breaks clear off.

I don't think it is the pressure tank. A bad bladder allows the air to escape giving short cycles, but the pump continues to reach full pressure.

mgoody

Sorry, but I don't think you have any option but to lift the pimp from the well in order to discover what might be wrong with it. As already stated by Labman, the condition of the pressure tank/bladder does not affect the pump's ability to generate pressure. Some possible reasons for your problems are: sand etc. partially blocking the pump inlet, worn impellers caused by sand abrasion, air lock due to excessive draw down of the well water level - this could result in the pump failing to reach its cut out pressure, and if the impellers and diffusers etc. are made of plastic they could have suffered heat damage and permanent loss of performance. Good luck!

Hoodoo

I sure appreciate you answering my question. And yes there has been a reduction of water flow. I was hoping that maybe it could have been the pressure tank.... would have been a little easier to cure... More investigation into the pump and line. Thanks again...

Hoodoo