 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Stanadyne
I have a Stanadyne single tub/shower faucet in the guest bathroom which has not been used for several months. Only hot water comes out now. I've read the comment of removing the cartridge. I've removed the copper retainer clip, replaced the handle, pulled as hard as I can, but it won't budge. Any further advice?
|
||||
|
||||
|
This is a Moen product. Moen makes a cartridge puller, (see image) for those stubborn cartridges. If you've removed the copper clip then take the hadle off and use the puller to remove the cartridge. You can pick up the cartridge puller at most plumbing supply houses. Check the inlet ports for any trash and then place a pan over the open valve and turn the water back on to flush out the supplies. Turn the cold watere on first and check for a strong stream, Reassemble and test. Good luck, Tom |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
What cartridge should I be getting, single handle unit. Water comes out by handle. Leaking all the time. Replace with meon 1225, but little water flow out of spout and devert to shower small amount. Do I have wrong cartridge?
Hi: Had a problem with water pressure from the shower head. Lots of pressure from the spout. Ran a snake down the shower pipe to the valve but I think I damaged something in the valve as now when I pull up the diverter in the spout, no water comes out anywhere. Any suggestions. I also can't...
Hi all, I've just closed on my first house, and over the past couple of days, I've noticed that in our master bedroom shower, when I pull up the diverter to switch the water towards the shower, about half of the flow continues to go into the bath, while the water that does flow to the shower...
How do I remove a Stanadyne shower valve installed behind a fiberglass shower stall.
My stanadyne shower diverter leaks. How do I take it apart?
View more questions Search
|
