Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Rain shower head & handheld shower head problem
[ 4 Answers ]
I have a shower with 2 pipes for showers heads (one on the wall in front, and one on a side wall). The wall in front has a rain shower head on it. The wall to the side has a hand held shower head attached. The pipe with the hand held shower attached has a push button valve to turn the handheld on...
Leaking shower diverter valve
[ 15 Answers ]
We have a three knob shower system. When the water runs into the tub a significant amount of water runs out of the central diverter valve (?correct term) knob. When this is turned water is diverted to the shower head. How does one determine how to remove and replace the diverter assembly, or could...
Water leaking out of shower head.
[ 6 Answers ]
When I pull the diverter valve up the shower works fine, then I push it down I get a continuous stream of water out of the shower head. If I don't turn the shower on it takes about 2 minutes. For the water to get to the shower head while I am filling up the bath. Could this be a bad diverter valve?
Diverter valve problem
[ 1 Answers ]
Hi All, Had a problem with the diverter valve knurled end being worn, so I changed the whole valve(Danco replacement for Sayco). With the new valve, I have low pressure & also when putting water towards the shower head, it still comes out the lower spicket. How does that happen. Thanks in...
Shower diverter valve sticking
[ 5 Answers ]
Howdy, hope someone can give me some advice on this sticky problem I'm having. Just recently the diverter knob (it's a pull-out type) has been sticking a bit, not pulling out all the way. The result is the water comes out of both the tub faucet AND the shower head, at half-pressure from both. It... View more questions Search
|