Check out some similar questions!
How to replace Symmons diverter Handle part T-30?
[ 6 Answers ]
This piece is made of plasic and broke off at the 90* neck angle. (at least it is stuck on shower mode which, if it had to break, is what I would prefer.) I have ID'd the part # but have a couple of quesitons about replacing it. First, how difficult is this for the average joe? I have a diagram...
Symmons - Temptrol Diverter
[ 22 Answers ]
I have the above diverter in my bathroom. Recently it started to leak from the diverter handle that changes the use from tub to shower. I purchased the Symmons TA-25A Iverter Spindle to replace old. My problem is that I do not know how to remove the old spindle. Can anyone help me with my problem?
How do you replace the Symmons temprol diverter
[ 1 Answers ]
How do you replace the temprol diverter in a Symmons single valve shower/tub assembly?
How to replace symmons spindle
[ 1 Answers ]
How do you remove old symmons spinde and replace it with a new spindle and diverter Handle??
SYMMONS Temptrol leaking from diverter
[ 1 Answers ]
Symmons sent the replacement seats and tools to repair a leak from the diverter hole that happens only when water is turned on. I replaced the seats, tightening by hand stopping short of cranking them. (I didn't use a torque wrench). Three times I removed them and adjusted them, but the... View more questions Search
Add your answer here.
|