Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Replacing Sink Air Vent
[ 3 Answers ]
I am planning to install a new kitchen sink. The present sink has an air vent installed in the "fourth" hole (Chrome plastic vent). I want to install a sprayer in that hole. The dish washer and disposal are connected under the sink into the vent valve by a y connector. If I used that hole for the...
Repairing/replacing exhaust vent boot
[ 1 Answers ]
How do I repair/replace a roof exhaust vent boot?
Replacing Bathroom Vent - What Size PVC?
[ 8 Answers ]
This is a vent/drain setup I'm replacing. Currently, the drain is 1.5" PVC. The vent is 2" cast iron. Do I replace the whole thing with 2" PVC? Or do I replace the drain with 1.5" PVC and the vent with 2" PVC? For the vent I have pointed to with the "Connector Type?" arrow - I am planning on...
Removing and replacing the vent pipe
[ 4 Answers ]
I have started remodeling my bathroom. When I tore a wall out and found the iron vent pipe. Now the pipe will be in the middle of my bathroom. I have been told that this pipe is very heavy and I should leave it alone. I am want to know what is the easiest way to take the pipe out and what type...
Vent diagram - does this meet code (see pic)? Vent runs below actual drain
[ 4 Answers ]
The schematic below should make it clear the configuration I would like to use. Basically, I would like to keep the vent under the floor for a little ways, so it pops up in a better location. I cannot easily move the 2" drain location going down and would rather not go straight up from the... View more questions Search
|