Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Old Lennox thermostat to Honeywell.
[ 2 Answers ]
This is same another question but not understanding. I am trying to replace a heat pump thermostat on a fuel master plus 1-1. The heatpump has LP furnace for back up heat. It was a Lennox Thermostat and I am replacing with a Honeywell. On the Lennox I have R, V, VR, F, M, L, A, Y, X. Honeywell is...
Replace lennox thermostat with new honeywell RTH7400
[ 1 Answers ]
My old thermostat is to be replaced by a newer honeywell programmable RTH7400. The wires on my Lennox are as follows: O,G,Y1,R,L,T- ( jumpered to C ),W1,E. The W1 wire is connected to the old thermostat. Pretty easy here, but the T is not used anymore and the Y1, W1 wires ire throwing me off?...
Lennox to honeywell thermostat
[ 3 Answers ]
Im trying to replace a lennox therostat with a honeywell - the heat is working but the air is NOT When I wired the new thermostat the wire marked with w1 and o from the lennox did not match up - the instructions showed the wires both going to the same place - I hooked up the w1 and taped off the...
Lennox thermostat with Honeywell RTH7400
[ 1 Answers ]
Replaceing Lennox thermostat with Honeywell RTH7400 -------------------------------------------------------------------------------- ------------------------------------IF I CONNECT THE O THEN WHERE WILL THE W1... View more questions Search
|