Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Slow Bathroom Sink Drain - but Tub and Toilet Drain Fine
[ 4 Answers ]
I am hoping that someone can offer a suggestion to solve my problem. We recently purchased a 60 year old home. The sink in one of our bathrooms drains completely fine until the water has run for about 5 minutes and then all of a sudden it starts to back up and then drains very slowly. I have...
Trap Diameter requirements
[ 5 Answers ]
Tom, I had asked some questions previously for roughing in plumbing for a basement. I have a few more questions for you. 1) Does code require the trap to be the same diameter as the trap/waste arm? For my wetbar I ran a 2" horizontal waste line to where it is roughed at of the wall. Does...
Extending utility sink drain for bar sink
[ 2 Answers ]
I have a utility sink in my walk-out basement - that sink's 1.5 inch drain connection is approx. 18" above the floor, into a two inch horizontal run. This 2 inch horizontal PVC runs about 3 feet, then connects to a main 3" DWV. I would like to add a bar sink, set into a standard height (36")...
Kitchen Sink/Laundry Sink Drain Vent Non-exist
[ 3 Answers ]
The set-up from kitchen sink leading down to drain to basement: 1. Kitchen sink - (R side) - connected to a P drain I think you call it -PVC-, connected to a "metal" T, which has a Studer vent gizmo attached to the top of it, then draining into a metal pipe straight down to the drain in the...
New sink drain 2" off from existing drain
[ 4 Answers ]
Sorry for the dumb novice question, but thanks in advance for the advice. My new lavatory sink's drain is 2" away from lining up with the existing p- trap drain pipe. I REALLY don't want to cut off the whole p-trap drain to install a new one that would fit where I need it (as someone has... View more questions Search
|