Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
How to remove fitting from PVC Pipe
[ 1 Answers ]
Have a cleanout valve that need to be extended. Need to know how to femove the fitting without cutting it off.
Compression fitting on soft cooper pipe
[ 5 Answers ]
Is it possible to install a 3/4" valve with compression fitting on soft cooper tubing 3/4" as well? Will it fit? Will it hold? Tank you
Plumbing supply pipe
[ 2 Answers ]
What kind of pipes can I use to connect the hot water supply in my shower other than galvanized or copper? Thanks
50mm solvent weld, plastic pipe fitting?
[ 1 Answers ]
I'm trying to add some pipe work to what I thought must be a 50mm Solvent Weld type Tee piece. But when I measured the internal diameter of the tee piece it is actually 55mm and the 50mm pipe I have just rattles around inside. I thought that waste pipe only came in 50mm, is there such a thing as...
Removing galv fitting from cast iron pipe
[ 4 Answers ]
What is the best way to remove a threaded stuck lead fitting from a cast iron section? The fitting was from a lead sink drain pipe and it connected to the cast pipe at the toilet elbow. I tried a pipe wrench and a hammer to try to budge it but no go. I want to thread new PVC into the section of... View more questions Search
|