Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
New well pump vs. New holding tank
[ 2 Answers ]
Hello all. This is our first house with a well & septic system. The well pump(submerged) is approximately 18 years old and has never been replaced to my knowledge. We are now experiencing very low interior house pressure when outside spigot is in use or when washing clothes, showering, etc....
How much water should be in the holding tank of a well?
[ 5 Answers ]
I live in the oldest house in the world - 1861. From what I can tell the plumping was put into the house in the 1950s but I assume the well has been there since forever. Anyhow - we have had a lot of issues over the past 20 years that we lived there. We had a plumber out that pulled the pipes...
Sewage pump clogs in holding tank
[ 1 Answers ]
We have two new SK60 submersible sewage ejector pumps in our holding tank at a 28 room motel and they keep clogging up with things like plastic bags, string etc. . What can I do to prevent this?
Well pump takes 5 minutes to fill bladder holding tank
[ 12 Answers ]
Last year we installed a new bladder holding tank. Pressure set at about 27 lb since pump turns on at 30LB. After installation pump was running a long time to fill pressure tank. If drawing water from multiple sources at one time once pressure dropped and pump went on it could not supply enough...
Septic holding tank manhole adjustment
[ 3 Answers ]
Hello, I had my house built last year and the septic system is a sand mound system with 3 holding tanks between my house and the sand mound. The holding tanks are concrete and each have an access (manhole) that sticks about 1' out of the ground. I have read on other sites about access being... View more questions Search
|