Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
4'' cast iron vent stack through the roof
[ 6 Answers ]
Hi, Newbie here & need some advice on a recent bathroom re-model. When the walls were opened up, the 4" cast iron vent stack was badly corroded & replaced with about 10' of pvc going into the attic. Instead of going all the way through the roof with pvc, the guy doing the job connected the pvc to...
Cast iron to pvc transition for main vent stack
[ 4 Answers ]
Hello to all. I am adding a 2nd story to my home. I have a 4" cast iron vent that y's off to pick up a galvanized 2" pipe for the bathroom below. I have a 2 part question. (A) The vent runs horizontally at a 90 for about 6 feet, then goes up through the roof. I would like to cut this out,...
Cast iron vent stack and PVC waste lines
[ 1 Answers ]
I decided to replace the cast iron portions of my waste lines from a double vanity sink to the waste line. Previously a plumber had replaced the accessible portions with PVC so I have quite a mix. Now that I have opened up the wall, I see that I have a cast iron vent stack / hub (see pics: ) that...
How to vent after connecting PVC to cast iron sewer main?
[ 7 Answers ]
I am connecting a PVC "y" to my main sewer main which is cast iron. The drain itself will only be about 7 feet from the connection. Should I vent? And if so where? Thank you for helping a helpless do it yourselfer.17737 17738 17739
Cast iron vertical from cast iron horizontal can be pvc?
[ 2 Answers ]
A leak developed in the main cast iron vertical stack of pipes leading to the horizontal main drain. Unfortunately, for me, the leak was so close to the ground that I had to break the concrete slab of the house. At that point, it just made sense to dig an extra 4 inches or so and remove the bad... View more questions Search
|