1 Answer
Not your question? Ask your question View similar questions
Add your answer here.Check out some similar questions! Need to replace 'O' rings and Gaskets in Delta Faucet [ 1 Answers ] My Delta faucet which is probably 30 years old constantly drips. I have replaced the shower head so know it is the faucet. It is a single handle push up for on and twist to the right or left for temperature control. How do I replace the o rings and gaskets? Thank you Faucet leak from middle hole - leak under cabinet [ 8 Answers ] I hired plumber to install new faucet on my kitchen sink and bathroom basin. He did a good job with it, but while he was installing them he did not use silicon putty under the faucet gasket. I told him or remind him to do that but he still didn't Water suppressor needed on lavatory faucet and shower faucet? [ 1 Answers ] Are water suppressors needed in the bathroom sink faucet and the shower stub out also? And can you just use a lenght of pipe on a T, or must you use those copper chambers? (cpvc system) thanks Take apart faucet to repair leak [ 1 Answers ] I have a Delta 2 handle kitchen faucet which I believe is a Peerless faucet. It has a long goose-neck spout and separate sprayer. How do I remove the handles. Does it take a washer, an O ring or both? Bathtub Faucet Leak [ 1 Answers ] I had this same problem in the summer of 2005. :( After using my shower, I'd cut off the water and the bathtub faucet would either drip slowly or moderately run. Had new washers put on in 2005. Just noticed (Oct 5 or 6 2006), that the same problem is reoccuring. Please verify for me the... View more Plumbing questions Search |