Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Toilet lead piping too short
[ 2 Answers ]
The lead piping going on the toilet ring is too short and do not cover the brass ring at all. I purchased a new lead piping section which needs to be solder on the old lead piping. How do I solder this lead section to the old lead piping?
Replace Lead Pipe from Toilet to Hubless Waste Pipe
[ 3 Answers ]
My house is a craftsman style house from 1912 in Oakland, California. I have a big hole in a 24" horizontal lead pipe that bends at 90 degrees and connects the only toilet in the house to the hubless waste pipe. How do I go about removing the lead pipe? (What tools do I need and what type of...
Lead Bend Toilet Flange
[ 4 Answers ]
I think I have a real problem. In a bathroom remodel the plumbers left a 4" lead bend with about 6 inches above the new floor height. The tiling contractor cut the lead bend even with the floor, (about 1/4 inch above the tile). I gather from other wuestions that I don't have enough lead pipe to...
Lead bend
[ 7 Answers ]
My master bath had a leak at the toilet so I pulled the toilet up and found that the closet flange and the lead bend where no good. The lead pipe is so bent and you can allmost put your finger threw it the lead bend goes into a cast pipe and I would like to replace the bend if anyone has a clue on... View more questions Search
|