Sewage pump clogs in holding tank

I frequently run out of hot water in the shower. I have a furnace that heats the water directly. My question is; Can I use a hot water heater as a holding tank, so I don't run out of hot water? If so what do I need to complete this task?

I have a downstairs bathroom connected to a tank with a pump to move sewage up & out to our septic system. When the toilet is flushed, the water drains slowly, the bowl almost fills completely and the sink & toilet both start to gurgle & bubble. The drain line from the washing machine sink is...

Last year we installed a new bladder holding tank. Pressure set at about 27 lb since pump turns on at 30LB. After installation pump was running a long time to fill pressure tank. If drawing water from multiple sources at one time once pressure dropped and pump went on it could not supply enough...

Hello, I had my house built last year and the septic system is a sand mound system with 3 holding tanks between my house and the sand mound. The holding tanks are concrete and each have an access (manhole) that sticks about 1' out of the ground. I have read on other sites about access being...

Doe sthe Sewage tank need to be flush with the concrete or should it be reaised three to four inches. The hole for the 3" inch pipe is well below grade.