Search:
Type: Posts; User: waynemia
Search:
Search took 0.00 seconds.
-
I received some great comments today. I made a quick drawing. I probably used the symbols incorrectly but I think it will help me get organized.
I will look at trying to cut a hole for the shower....
-
The schematic of the circuit is necessary. The source voltage, switch location, resistor locations and values, capacitor location are all critical to solving the problem.
-
Short answer - No, Long answer - There was a sink and toilet in the shop when I bought it. The toilet outlet was in when the slab was poured. The sink drain went through the side of the steel...
-
Hi, search for old editions of the ARRL Amateur Radio Handbook. These have loads of useful information. You can also look for old versions of QST from ARRL. There are a lot of projects that you could...
-
The shower is near an exterior wall. I am afraid of creating leaks if I penetrate the floor. I am hoping to find a solution that gives me the lowest installation height. I will just raise the shower...
-
:confused: I was not planning to place a vent for the shower or the bath sink. I don't understand what could go wrong because they are pretty close to each other. If I vent at the far end, wouldn't...
-
I have three drains, kitchen, shower, and bath sink (in that order from Norht to South) that will run along the same wall. The distance is only about 16 feet. I was planning to place only one vent at...
-
I have a 40' x 40' shop that I am building an efficiency apartment in. The problem is the shower. I have a shower pan but I need to install the shower with as little platform height as possible. I...
|