Search:
Type: Posts; User: btc
Search:
Search took 0.00 seconds.
-
Thanks for the responses guys, but this may not be what I have. It is mud set etc. but after pulling the stainless ring out this morning (I had to chip tile out around it and it just lifted out), I...
-
No problem.
The gear teethy thing is the valve stem. The valve or handle you use everyday attatches to this. This is what you are going to eventually pull out to replace or clean. The next piece as...
-
Can not believe I am reading this post. Nice to meet you. You may have found your answer, not sure. I was/am in the Same situation. I replaced a toilet that was constantly clogging or slow, but the...
-
In looking at your picture again. There does appear to be a hex nut, center front under the valve stem. It is on what looks like a U part of and on the valve body under the stem. Not sure that is...
-
You have to remove the bonnet, which is the 'nut' at the end where the handle goes on the valve. You can use a crescent wrench. This would expose the cartridge which should pull out somewhat easily...
-
Hello,
I am replacing my shower floor and walls with new tile. The home was built in 1977 and the concrete sub floor is in good shape and can be worked with. I will be laying in a new pan...
|