Search:
Type: Posts; User: desipearson
Search:
Search took 0.00 seconds.
-
Clogged drain line or a bad drain pump are the two must common things that cause that problem.
-
Need more info. Does it stay lite for a while? What is the model number? There are a lot of different styles and it could be any number of problems.
-
If it doesn't stop filling there is a pressure switch that is supplied by a rubber hose that runs from the side of the drum to the water level switch. If this gets plugged the switch will not...
-
There is a hub made of placstic that wears out. Its located under the agitator. Pull straight up on the agitator inside the drum. The is a white cap looking piecewith a bolt in the top. If it turns...
-
Need more information to really help but start by checking the lid switch. If its broken the washer will not move after filling.
-
Ground level cleanout is a place you can access the main line from outside your house. Most of the time in my area its in the front flowerbed or yard. The main thing is its between the house and the...
-
If there us a sprayer there is a part called a diverter. If that gets plugged you will have little to no pressure. If you have hard water a water filter might not be a bad idea. I've had this same...
-
Get a new washer.the front loaders are more expensive and I think are harder to repair.top loaders use more water but cost less and when something does go wrong it costs less to repair. Easier to...
-
It might be a nightmare but it's the best thing to do. Gluing it can be a bigger nightmare over time. The cold temp makes it hard to get the glue to cure properly. Sorry for the bad news. Would...
-
You can suck as much water out *** u can with a wet dry shop vac. If that doesn't let air flow u will have to go under and put a small hole in the lowest point to drain it. Then coer it up with...
-
I agree with joy. There could be ice in the drain line also. Try unplugging it for a day and leave the door open.its a great time to deep clean it also.
-
Sounds like a wire got crossed. There shouldn't be any connection between the dryer ans washer wires except the power coming in. If a wire got crossed a resistor could be restricting current. I...
-
Where the water enters the tub there can be a restriction deflecting the water out of the tub. The supply lines between that point and the valves on the backcould be damaged.open the front panel and...
-
Well it could be a few things. First I would check the drain pump. If it can't drain it won't spin. Make sure power is getting to it and its not clogged.
-
Short move is no big deal just keep it upright don't lay it on its side I move washers all the time and never have to lock down the agitator. You will be fine no need for any blankets in the tub.
-
The paint will crack and peel if you heat a lot of things uncovered. The heat and stem wear away at the finish over time.leaking microwaves will not cause that.
-
It probably is metal yo metal. Depending on the model you have teflon strips that wear down and some models have a ball and socket joint at the back. These wear out. The jooint at the back needs high...
-
This is a kenmore dryer I asked another question but forgot to say what it was for . Thanks
-
I need to know what I can do to repair the dryer there is two codes that come up. The most resent is an f26 but there is also a f1 code .could they be related? How many codes can it hold and does...
-
I get the f 26 error code it will not reset or restart what do I need to replace to fix it
|