Add your answer here.
Check out some similar questions!
Shower head leaks when tub is filling? [ 3 Answers ]
I ran the tub spout in wirsbo pex with four 90s but the shower head goes straight up with no fittings. Would it fix the problem to run the riser in 3/4 would it fix it? Would the area of a 3/4 pipe be enough to keep the water at bay? The pressure is at 40psi...
Shower Leaks when Tub is On [ 13 Answers ]
My shower head leaks when running the tub. Not a lot, but enough that it drips down, hits our shower caddy and splashes out of the tub, making the floor all wet. I have replaced the spigot, with no improvement. The image below shows our setup. It's all Delta. ...
Shower diverter leaks into tub when turned to shower [ 2 Answers ]
I'm trying to replace my shower diverter valve since it leaks into the tub significantly when turned to the shower. It's a 3-knob system (hot, diverter, cold) and I don't know the brand. I've gotten the knob off, the surrounding piece off, and one nut off, but I'm not sure what to take off next...
Delta tub spout leaks when using shower [ 1 Answers ]
Our Delta tub spout leaks when we use the shower. I have remove the spout and was going to replace it with a universal spout. However, when I unscrewed the spout I noticed a large, threaded copper sleeve remained attached to the copper water pipe. I can't seem to remove or twist the copper...
New shower leaks while tub runs [ 1 Answers ]
I just installed a moen villetta tub and shower faucet and it leaks from the shower head when the tub is running and the lever is set halfway between hot and cold?
View more Plumbing questions Search