 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Rheem 21VP50E-1A powervent with powerGIO ignition system
If I turn on unit,the pilot is working and flame is on. But 10-20 second later, the flame is off(this unit have a continuous re-try 100%shutoff electronic module)
Why is the flame off just 20sec later after the burner is on |
||||
Check out some similar questions!
When my furnace starts up for the first time, only two of the three burners ignite. The third burner (far left), which has the flame sensor in its path, does not ignite; however, if I blow the flame into its path, the burner will ignite and the furnace will heat without further issue. Sometime,...
I have a Rheem Power Vent 21VP40E-1 tank water heater. The vent fan stays on constantly but there is never an attempt to ignite. I have reset the unit, but problem persists. Any suggestions from the informed?
I have a Rheem gas water heater. My heater has a hot surface ignitor. I don't think my ignitor has a flame sensor, but it may be incorporated. It is a round ignitor. White on the bottom with a black spiral heating element. It has 2 wires coming out of the bottom. It is white on top (looks...
Help; I have installed a Uni-Line 721-008 pilotless system in my 1979 Rheem RRAB-08E48JR rooftop HVAC unit. I have 3 original wires to hook to the new unit that has 2 wires (black and gray) remaining to be wired. 1 original old black wire comes from the transformer into the heater...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
