Check out some similar questions!
Rheem Criterion II ignition problem.
[ 0 Answers ]
When my furnace starts up for the first time, only two of the three burners ignite. The third burner (far left), which has the flame sensor in its path, does not ignite; however, if I blow the flame into its path, the burner will ignite and the furnace will heat without further issue. Sometime,...
Rheem power vent ater heater: Vent stays on, no ignition
[ 0 Answers ]
I have a Rheem Power Vent 21VP40E-1 tank water heater. The vent fan stays on constantly but there is never an attempt to ignite. I have reset the unit, but problem persists. Any suggestions from the informed?
1992 Rheem Powervent Gas Water Heater
[ 0 Answers ]
I have a Rheem gas water heater. My heater has a hot surface ignitor. I don't think my ignitor has a flame sensor, but it may be incorporated. It is a round ignitor. White on the bottom with a black spiral heating element. It has 2 wires coming out of the bottom. It is white on top (looks...
Wiring new 712-008 pilotless ignition to old Rheem rooftop unit
[ 1 Answers ]
Help; I have installed a Uni-Line 721-008 pilotless system in my 1979 Rheem RRAB-08E48JR rooftop HVAC unit. I have 3 original wires to hook to the new unit that has 2 wires (black and gray) remaining to be wired. 1 original old black wire comes from the transformer into the heater... View more questions Search
Add your answer here.
|