Residential well pump: pressure tank/switch problem

I have a york furnace P2MD12H06401A after 1 hour it shuts down and gives a 2 flash error for a stuck pressure switch. The switch is new can it be wired wrong? The old one had 2 white wires piggy back and 1 blue wire. The new switch has 3 separate terminals

I have a new home with nothing but the 1inch well pipe stemed through the cellar wall. My house is not on town supply line. Do I need to install a jet pump that goes to the pressure tank which then sends water ot a holding tank? Or is the pressure tank by itself all that I would need? Or a...

My well pump is about 150 yards from my home where I want to install a bladder tank and pressure switch in my basement. I have been told that I can not do this because of the distance to my pump. I have a submersible well pump and the only place I have to put the bladder tank is in my basement. ...

The well is reportedly 350 feet deep, Franklin pump control rated for 1hp Square D pressure switch Champion bladder tank about the size of a 30 gallon water heater One inch cast iron Inlet from the pump. I suffered from low water pressure for a couple of years, then started messing with this...

I live in a rural area and my home is supplied by a well with a submersible pump. The water comes into a bladder pressure tank. I have noticed that when the shower or the dishwasher is running, the switch for the submersible well pump keeps switching off and on. I am worried that I will burn up...