1 Answer
Not your question? Ask your question View similar questions
Add your answer here.Check out some similar questions! Well water loses pressure. No pressure tank? [ 12 Answers ] We have lived in our home for 2 years. We have no way of contacting the previous owner to ask about the well. It is a submersible pump and the only think above the ground is about a foot and a half of the pipe and cap. There is no pressure tank that we can find. Our old place had an actual well... Pressure/bladder tank losing pressure? [ 11 Answers ] Well, I have asked some questions about my plumbing before. So I am calling on you guys once again. I have a 52 gallon pressure tank/bladder tank made by wellsaver. I turn the water on and have good pressure for a few minutes then it basically goes dead with no pressure. I recently posted questions... Pressure tank problems [ 10 Answers ] I had a drilled well installed at the cottage about 3 years ago. They also installed a submersible pump and a new control switch at the pressure tank. At least a couple of times a year, there is no water coming out of the taps. When I go to look at the pressure tank, I notice that there is no... Do I need to install a jet pump, a pressure tank and a holding tank? [ 6 Answers ] I have a new home with nothing but the 1inch well pipe stemed through the cellar wall. My house is not on town supply line. Do I need to install a jet pump that goes to the pressure tank which then sends water ot a holding tank? Or is the pressure tank by itself all that I would need? Or a... Deep well, pressure tank/switch not building pressure [ 13 Answers ] The only way I have water pressure is to leave the power on! I have replaced the 5 gallon pressure tank (28psi when void of water)/fittings/pressure gauge and tried 3 new 30/50 pressure switches and the problem remains the same. With the power off, the pressure drops to 0 (not 30). When I... View more Plumbing questions Search |