At Ask Me Help Desk you can ask questions in any topic and have them
answered for free by our experts. To ask questions or participate in
answering them you must register for a free account. By registering you
will be able to:
Get free answers from experts in any of our 300+
topics.
I'm installing a rubinet wall mount faucet. The 1/2 inch threaded male (piece which connects to a copper 1/2 inch female piece in the wall) has little teeth or grit made into the threads. I'm thinking this is to allow the piece to get a good hold, tight hold, without having to be seated. Any body got info on this type of thread? Thx
Hey Mr. Nile,
Chickens and pipe threads share a common trait. Neither one of them has teeth.
Marks most likely correct. You probably got a manufactures defect. Take it back and exchange it or keep it for a conversation piece. Cheers, Tom
nah guys the threads are supposed to be this way ( would post a pic, but fixture is at job site) if you look closely at the threads there are small (tiny) teeth like things. They are on both the threaded connections. ( this is a wall mount bridge. connects at through wall at a hot and cold.) this fixtures comes from canada, maybe its some sorta revenge on the canucks part : ) seriously, if you find out what they are called let me know thx
That's coool Denile,
I popped over to your job site and took my own picture,(see image).
You're tralking about the spout, correct? Let's figure the threads are there for a reason. What could it possibly be??
Ok! Here's my take on it. you would never see teeth on a thread that has to hold pressure, but just a minute, the threads on a spout don't have to hold pressure. All they have to be is watertight. Let's say you had threads without teeth and you tightened the spout but it tightened up with the spout looking up instead of looking down. Yet when you turned the spout down it was too loose. I think those teeth are there to insure a good grip i you have to back the spout off a tad so it would line up. As with all threads I would apply a few wraps of Teflon tape for insurance but I believe the teeth will still insure a grip. I also believe that this is a special thread for this type of valve se don't look for it in the big box stores soon.
Ya got my best shot; Sorry If I missed the boat. Tom
Hey speed I think your close to why they are teethed. heres the model # and web site of the actual faucet Rubinet Wall Mount Kitchen Bridge Fuacet 8WRBRVC
Oh also the connections are off set ( what tha !!) so for the faucet to be level they have to be tightened to the same position, Thats why I think your on spot about position
this reminds me of a T&S commercial sink fuacet(sort of). Can you explain exactly what the teeth look like, where they are located on the thread. If you get a chance to take a pic, i would really appreciate a learning experience. Thanks, Lee.
The threads themselves had small slits so that they were teeth. I called the rubinet people, they said just turn the connection till it gets tight and then turn till you get the position you need, The faucets have 2 connections each, and each connection is offset, so you have to make sure each one is in the same position or the faucet will not line up or be level. Put em in yesterday, what a pain. Took 3 tries to keep em from slight leaks, Hard to seal because of dang teeth!
Sounds like somethingthat needs to be wire brushed off the threads.
Linear Mode
