I am sure this has been posted and asked on here many many times but need some advice on this...We have been noticing lower pressure to our hot water faucets in our home over a period of the last couple months. Most noticeably at the shower/bath faucet. The shower head actually has an annoying squeal when the hot water is turned warmer.

I have tried flushing HWH in the past but that has not done anything. I am going to try to do that again tonight but more thoroughly and take it from there.

If there is any more things that I can try as a homeowner, please let me know as I want to avoid calling a plumber to avoid them costs if at all possible.

Much thanks in advance.

speedball1

Pump or city water? If on a pump is there minerals in the water? What kind of water pipes? Have you removed the water saver from the shower head and soaked it in white vinegar? Regards, Tom

ejj88

Thanks for the reply.
I have city water.
I was getting some deposits showing up in the stains on the kitchen sink faucet a few months back so not sure what or where that was coming from.
It has since stopped so I would say that yes I have had some deposits going thru the pipes in the past. The pipes are copper.
I have removed the shower head to see if there is any blockage there but have not removed anything or took apart the shower head. I will look at that tonight to see if it can be taken apart. I did replace the shower head a while back and that did nothing for my problem.

Any other ideas???
THANKS AGAIN.

speedball1

OK,
Give me the brand name of your tub/shower valve and it's age and I'll instruct you on how to clean it and flush out your supplies. Regards, tom

ejj88

Are you referring to the shower head itself?
It may have some blockage there, yes, but the low pressure is at all how water outlets.

speedball1

Then the problem's in the hot water system and not primarily in the T & S valve as I thought. Mineral builds up in your water heater and if it's not flushed out on a regular maintenance schedule will eventually be drawn up into your pipes and clog the inlet ports and supplies of the hot water system. I know you've been flushing your heater but let me show you how one more time
Attach a hose to the boiler drain at the bottom of the tank. With the pressure on, open the boiler drain and let it run untill the water runs clear. You will see a spurt of red,(rust) followed by white grains,(lime or calcium carbonate). This shouldn't take more then a few minutes. Do this monthly to keep it clear. Don't forget to flush it out every month. Your heater will thank you for it.
This is just the begaining. After you flush the heater out, (by the way how old is the heater?) you will have to start at the first faucet after the heater and open it up, clean out the seats and/or inlet ports on the cartridge and then turn the water back on before you reassemble to flush out the supplies. Then move on to the next one and do the same thing to every faucet that's affected. I realize this is a hassle but I know of no other way except a repipe job and new faucets to make things right. Good luck, Tom

ejj88

The HWH is over 8 years and probably somewhere around 10 years old. I am starting the think that it needs replaced because I if I am getting some residuals from the faucets now, those have to be coming from the HWH and even if I find the clog-it will probably only return. Am I not correct in thinking this?

How much labor timewise would go into replacing out a HWH?
Thank you.

speedball1

I can drain, unhook and replace a waterheater in under 2 hours.
" even if I find the clog-it will probably only return. Am I not correct in thinking this?"
The clog you refer to is in the system and the faucets. It's not just one clog. Every faucet has drawn the "residuals" up into the cartridge inlet ports and/or the seats.
After you replace your heater, (The average life of a water heater is 8 years) You will still have to purge your system and faucets of the crud that has been accumulating over the years. Once you have your system back and running make it a habit to flush yout heater. Good luck, Tom

ejj88

Thanks for the advice, Now to decide whethere to pay the labor or tackle myself. I had a buddy offer his assistence so may go that route.

speedball1

If we can be of any assistance please feel free to call upon us. Good luck, Tom