|
|
|
|
New Member
|
|
Apr 23, 2014, 08:24 PM
|
|
Leak from the cold faucet behind the shower wall
The leak on the left pipe. It seems repaired by someone else in past. I don't know if it is fixed properly. How much do you think a plumber will charge me for the repair?
|
|
|
Uber Member
|
|
Apr 24, 2014, 04:28 AM
|
|
Hard to tell, depends on local labor rate. Looks pretty sloppy but it might be a cracked valve body and the whole assembly may have to be replaced.
|
|
|
New Member
|
|
Apr 24, 2014, 09:53 AM
|
|
Can you give price range for the assembly replacement?
|
|
|
Uber Member
|
|
Apr 24, 2014, 09:57 AM
|
|
Are you in rural Arkansas or In the Hamptons?
Labor rates vary significantly by location.
And any estimate we might give....won't be followed by any plumber local to you.
|
|
|
New Member
|
|
Apr 24, 2014, 10:00 AM
|
|
Let s say I am in middle.
|
|
|
Uber Member
|
|
Apr 24, 2014, 05:48 PM
|
|
Go to Home Depot and price the complete assembly.
|
|
|
Senior Plumbing Expert
|
|
Apr 25, 2014, 03:55 PM
|
|
Hi YTK
Did this valve freeze at any time that you know of? It certainly looks like the COLD water pipe froze and "popped" the solder joint to me. Let me know, OK?
Mark
|
|
|
New Member
|
|
Apr 28, 2014, 04:27 AM
|
|
Yeah you are likely right because the home was vacant last winter. Also, the diverter was sort of jammed.
|
|
|
Senior Plumbing Expert
|
|
Apr 28, 2014, 05:30 AM
|
|
If that is the case, and the valve works other then a small leaker you can probably get someone in to resolder/reset the cold water tubing joint and that should fix this up pretty easily for you...;)
|
|
|
Home Improvement & Construction Expert
|
|
Apr 28, 2014, 06:08 AM
|
|
Since I see water stains on the wall board, and I don't see any water droplets on the pipe, I question exactly where this leak is and when does it occur?
Is the leak where the pipe joins the valve or does it occur around the valve stem. Does it occur all the time of just when the cold water valve is opened?
|
|
|
New Member
|
|
Apr 28, 2014, 06:41 PM
|
|
The stem in the cold valve was replace but the leak appeared worse. The leaks came out between the valve and pipe. The seller ordered a plumber to stop the leak last winter and they didn't specific the leak and told me it was fixed. I found out leaking from the 2nd floor last week. That is very possible that resolder would fix it, but I ordered the plumber to replace the assembly completely and the problem has solved and that is less headache for me.
|
|
Question Tools |
Search this Question |
|
|
Add your answer here.
Check out some similar questions!
Leak in shower faucet
[ 5 Answers ]
I changed out the hot valve the cold valve as well as the diverter valve, yet still a leak. I bought a kit so all washers and seats too. Any ideas?
Shower leak behind wall -- how to proceed
[ 0 Answers ]
Hi,
I have a shower/bath combination with a Mixet single handle valve. There is no leak on the pressurized system and when I run wanter into the tub through the downspout I have no sign of a leak. However, if I turn the diverter and run water through the shower I get a leak, as water starts to...
Shower faucet leak
[ 1 Answers ]
I have replaced the washers and it still leaks what could be the problem
Shower faucet leak
[ 1 Answers ]
My shower handle keeps slipping past the stop, therefore causing the faucet to continually leak. How can I stop this. I have taken the cap off the handle and tightened the screw to the off position, but it keeps slipping back. Does the screw need to be replaced?
Thank you
Shower leak from wall
[ 3 Answers ]
I have a problem relating to my shower. I have a leak coming from where the shower head goes into the wall. At first I thought it was just a problem from the shower head, but after I removed it, there is still a leak. The pipe the shower head connects to has water continually running out of it. ...
View more questions
Search
|