Ask Experts Questions for FREE Help !
Ask
    oddman53021's Avatar
    oddman53021 Posts: 3, Reputation: 1
    New Member
     
    #1

    Feb 7, 2011, 11:25 AM
    How to insulate pex pipe in unheated attic space
    I am adding a 2nd bath on the oppisite end of my rancher home, cold water is not a problem, to get hot water to the area I need to run in the attice space, I plan to use pex, I need comments on insulating the pipe.
    massplumber2008's Avatar
    massplumber2008 Posts: 12,832, Reputation: 1212
    Senior Plumbing Expert
     
    #2

    Feb 7, 2011, 01:15 PM

    HI Oddman...

    I'm not a big fan of running water pipes in unheated spaces, but if you must run the hot water PEX up in the attic, keep the PEX tubing down tight to the ceiling and encapsulate in foam tubing insulation. Then take the attic insulation and put that on top of everything with the vapor barrier toward the ceiling and that should be OK for you... ;)

    Questions? Let me know, OK?

    Mark
    Attached Images
     
    Handyman2007's Avatar
    Handyman2007 Posts: 988, Reputation: 73
    Senior Member
     
    #3

    Feb 7, 2011, 04:09 PM
    My suggestion would be to install a tankless instant water heater for the bath. If you run a hot water feed a long distance, you waste heated water that is laying in the pipe when done drawing hot water. A tankless heater would prevent that and you won't have to wait for hot water either, which is another waste of water.
    oddman53021's Avatar
    oddman53021 Posts: 3, Reputation: 1
    New Member
     
    #4

    Feb 7, 2011, 06:45 PM
    Comment on massplumber2008's post
    Thanks for the input Mark, I have been toying with this solution but I was thinking maybe there is another solution as my home is about 40 years old with 6" to 8" blown insulation over R13 batts under retrofitted hard pipe HVAC duct work with most of it laying on the joist. Back to the think tank, but I do thank you for your input.
    Oddman
    oddman53021's Avatar
    oddman53021 Posts: 3, Reputation: 1
    New Member
     
    #5

    Feb 7, 2011, 06:57 PM
    Sorry Handyman, I could not answer your input where it should be because an advertisement covered the space but any way, I am total electric and would have to upgrade service, panel, etc. For me not an option.
    Thanks for the input.
    Oddman
    Handyman2007's Avatar
    Handyman2007 Posts: 988, Reputation: 73
    Senior Member
     
    #6

    Feb 7, 2011, 07:08 PM
    I don't understand your response. You are total electric? I don't understand what that means.

    What about using propane at that location. It is much cheaper than electricity and much more efficient.
    My biggest concern for you is that wasted hot water. You are going to be heating water then letting it cool off. The cost of that alone would pay for a tankless heater and the propane.
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
     
    #7

    Feb 7, 2011, 08:12 PM

    I tend to agree with Handyman. A totally electric home is wasting a lot of money, electrcity is about as expensive as it can get. Bottle porpane or NG may not exits but are a good option. Is there no gas in your area? Bottle propane is available almost everywhere. I did a tankless heater in my fishing cabin and run propane. Some run flue gases so cool they exhaust via PVC

Not your question? Ask your question View similar questions

 

Add your answer here.


Check out some similar questions!

How do you insulate a cathedral ceiling with no attic? [ 8 Answers ]

How do you insulate a cathedral ceiling with no attic?

Cathedral ceiling with no attic on a 12/12 roof. How to insulate? [ 2 Answers ]

I have a 12/12 pitch roof, no attic, tin roof. I need to insulate it. It is new construction. Do I leave an airspace between the insulation and the plywood shething so that I can get ventilation through the soffits up through the vented ridge cap or so I stuff it full?

Pex re-pipe in attic, now cold water hot for 3-4minutes, now what? [ 2 Answers ]

We had our house repiped with Pex (in the attic) and now the cold water takes 3 to 4 minutes to get cold. We are on well water/pressure tank and live in the hot south central USA. The attic does get very hot. The Pex has a foam insulated cover around it. What can we do now? More insulation or...

How to insulate a converted attic space part2? [ 2 Answers ]

Area was existing when I bought it. I added some supplies and a return for the HVAC. Ok in the winter... too hot in summer. I found the rafters on the one side had no insulation(above the drywall) and the other had. The short section in the middle also had none. The rafters go down to the...

How to insulate a converted attic living space? [ 2 Answers ]

Area was existing when I bought it. I added some supplies and a return for the HVAC. Ok in the winter... too hot in summer. I found the rafters on the one side had no insulation(above the drywall) and the other had. The short section in the middle also had none. The rafters go down to the...


View more questions Search