Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
How to replace Symmons diverter Handle part T-30?
[ 6 Answers ]
This piece is made of plasic and broke off at the 90* neck angle. (at least it is stuck on shower mode which, if it had to break, is what I would prefer.) I have ID'd the part # but have a couple of quesitons about replacing it. First, how difficult is this for the average joe? I have a diagram...
Symmons - Temptrol Diverter
[ 22 Answers ]
I have the above diverter in my bathroom. Recently it started to leak from the diverter handle that changes the use from tub to shower. I purchased the Symmons TA-25A Iverter Spindle to replace old. My problem is that I do not know how to remove the old spindle. Can anyone help me with my problem?
How to replace symmons spindle
[ 1 Answers ]
How do you remove old symmons spinde and replace it with a new spindle and diverter Handle??
SYMMONS Temptrol leaking from diverter
[ 1 Answers ]
Symmons sent the replacement seats and tools to repair a leak from the diverter hole that happens only when water is turned on. I replaced the seats, tightening by hand stopping short of cranking them. (I didn't use a torque wrench). Three times I removed them and adjusted them, but the...
Diverter stem replace
[ 1 Answers ]
I Already Change The Diverter Stem On My Bathroom Shower. I Installed A New One (sayco). It Works Ok, Except When I Rotote It To Change And Send Water Only On Top Shower, Because It Send Also Water To The Bottom Shower (both ways). Do It Have Any Particular Way To Install It? Do I need to... View more questions Search
|