Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Submersable well pump problems
[ 3 Answers ]
Hello , I have a brand new "flotec 1/2 horse 10 gallon per minute 2 wire deep well pump and a brand new square 'd" pump controler on a pressure tank . The pump runs intermittantly . The controler is a 30 / 50 psi sometimes the press. Will drop below the 30 pound level & the contacts will...
Storage Tank or Bladder Tank?
[ 8 Answers ]
We just had a new well put in. The well person installed a 220 gallon storage tank (not bladder) when we turn on our sprinkler system our submersible well pump cuts in every 50seconds. We are using approximately 16 gallons per minute. Should the well person have put in a bladder tank instead of a...
Well pump takes 5 minutes to fill bladder holding tank
[ 12 Answers ]
Last year we installed a new bladder holding tank. Pressure set at about 27 lb since pump turns on at 30LB. After installation pump was running a long time to fill pressure tank. If drawing water from multiple sources at one time once pressure dropped and pump went on it could not supply enough...
Replacing a bladder tank
[ 2 Answers ]
I have a 18 year old Perma Tank PAD 20. According to all the prior dialog on this site about pressure drops and short cycling, it sounds like I have a ruptured bladder. The tank clunks all the way to the top and water comes out the pressure valve. I'm pretty handy. Is a bladder tank something I...
Bladder tank on well system
[ 1 Answers ]
Hello, thank you for attempting to help. I have a little water pressure in the morning, but after running the dish washer I have just a trickle. I have looked at the gauge at my tank and I can't get above 15 psi. I have also turned the power of to the submersival pump, turned the nearest faucet on... View more questions Search
|