Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Combo Wye and 1/8th Bend / Venting Question
[ 6 Answers ]
Hello. I'm installing a toilet/lav/shower in my basement (concrete slab). The toilet will drain through a 3 foot long 4" PVC pipe @ 1/4" per foot and tee into the existing vertical 4" cast iron main, which is vented through the roof. The lav will drain through a 4 foot long 2" cast iron main,...
Lead bend
[ 7 Answers ]
My master bath had a leak at the toilet so I pulled the toilet up and found that the closet flange and the lead bend where no good. The lead pipe is so bent and you can allmost put your finger threw it the lead bend goes into a cast pipe and I would like to replace the bend if anyone has a clue on...
Closet Flange
[ 1 Answers ]
I have a 3" PVC closet flange in my basement that is mounted to the cement floor and the flange is cracked in several spots and leaking. How can I repair it without breaking up the cement floor, is there away that I can remove the top of the flange and insert a new one.
Closet Flange
[ 12 Answers ]
I have seen quite a few questions regarding closet flanges but not exactly what I have going on. The toilet in my first floor bathroom has been leaking from the base so I decided to take the opportunity to update the entire bathroom. After removing the toilet I was shocked to find no closet...
Closet Bend
[ 1 Answers ]
Hi All, So, yes, I'm learning about plumbing. Please excuse the basic question... What is unique about a "closet bend" fitting? Also, is it applicable to a wall-mounted rear-drain toilet mounted to a wall with 6-inch studs and a near horizontal drain branch along the wall from the toilet?... View more questions Search
|