| In roadbuilding, when the ground moves as you have described, it is called pumping and it is an indication that special attention is needed at that area before attempting to build the roadway on top of the bad spot.
It sounds as if someone tried to correct the problem by removing some of the clay and refilling with old bricks or someone may have tried to create a "french drain" by using the bricks to create voids for storage and slow release of water.
If there is no constant supply of water (from downspout ug drains, septic fields etc) you may be able to remove the clay down to level of the bricks and refill with crushed stone (about 2" in dia. stones, no dust) and top off with topsoil.
If there is constant supply of water draining to the area, it maybe necessary to pipe the water to a better area to drain to. Clay is almost always a problem and clay with a water supply is a big problem.
Since the area is small, a reinforced concrete slab might "bridge" the pumping area but dont put the clay on top of the slab when backfilling. Find some good fill material.
Many of these areas we would find building roads were found to be old dump areas. That could be the origin of the bricks also. if that were a possibility. I would go to the concrete slab and skip the other steps.
These are just some ideas and I have never seen the area in question, just my best educated guesses. |