Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Riding Lawn Mover with Briggs and Stratton 14 HP motor
[ 8 Answers ]
I have a riding lawn mover with a 14 hp briggs and stratton engine. I cannot read the model number and I need engine parts (intake valve and keeper). How can I order a part if I don't know engine model??
12 hp Briggs Stratton Getting too much gas
[ 1 Answers ]
I have a 12 hp B&S engine. So far I have can gget it running, but when I push the choke all the way in it appears to flooding with fuel. Have cleaned the Carb and checked all linkage. Also when the engine has sit overnight it will start up and run fine, but after a few minutes it will flood...
How to adjust governor on older 8HP Briggs and Stratton mower motor
[ 1 Answers ]
I had to dismantle two engines to make one. Have forgotten how to adjust governor. I have fully closed buttefly in carby, and turned governor actuating lever fully anti-clockwise before re-tightening clamp on governor arm. Is this right or wrong?
12.5 briggs and stratton motor repair
[ 2 Answers ]
I have replaced conrod but have stuffed up settings. Do not know correct position of piston related to tapped setting
Briggs &stratton 15 hp.
[ 1 Answers ]
The other day this engine just quit and I had no spark from the coil. It has the electronic ignition so I cleaned everything under the flywheel and put it back thinking that this must be the problem but no. There is a small wire that goes to the coil and when I pull it off it will fire. I found two... View more questions Search
|