Search:
Type: Posts; User: zeustogo
Search:
Search took 0.00 seconds.
-
I have fixed it temporarily. I removed the wires from the elements. I had 12.7 ohms across the top element and OL across the bottom element I also had some resistance from each bottom element screw...
-
Thank you Mark and Tom for trying to help me. I took a picture of the wiring before I removed the old thermostat and put it back exactly the same verifying it with the picture I took. That is how it...
-
It still over heats. I replaced the upper thermostat. I had 240 volts to top element for about a half an hour and 0 volts across the bottom element. Than the top element had 0 volts across it and the...
-
Breaker to electric water heater was tripped. I reset it and about 6 hours later water was scolding hot. I have turned breaker off. Was working fine before, nobody has changed anything. What are some...
-
Checked pressure in heating mode. High side went to 450psi it pegged the low pressure. Put high pressure gauge on low side and pressure built up to 400psi and then I shut it off. Switched to air...
-
Just moved in and have a Rheem Heat Pump. In heat mode the fan runs constantly and after a little while the reset button on the condenser trips. I reset the condenser unit by pushing the red reset...
-
Battery operated flush urinal won't flush after installing new flush valve. Old flush valve had a small break in the bottom of the flush tube. After installing new flush valve it operated fine for 2...
-
One of my Reznor XL200 hanging heater is creating a smell like burnt gas that some people are complaining about. Once and a while I got a small wiff. One heater is cycling on and off about every...
-
My 1999 Mercury Villager has the air conditioning compressor cycling on and off in heat mode with the temperature selector all the way up. The tubing from the compressor is sweating. The engine is...
-
My 1999 villager air conditioning compressor is cycling on and off in full blown heat mode. In the mean time the engine is over heating. The fan seems to be cycling on and off but only on for a few...
-
It also sounds like it is not sensing the inducer fan. Check your connections from inducer fan to gas valve.
-
What were you pressing your screwdriver against?
-
Found the problem. There are two wire terminals located by the thermocouple port which say E.C.O.. Evidently that stands for emergency cut off. I disconnected the devive that was attached there which...
-
With old thermocouple pilot flame would hit thermocouole perfectly and with plenty of flame as I would try to get pilot to stay on. I repeated a full 60 second attempt 5 times in a row. I figured a...
|