Search:
Type: Posts; User: xcountry292
Search:
Search took 0.00 seconds.
-
-
-
Is the hole that you cut in the floor to bring the pipe up, big enough for the entire shower drain assembly or just the pipe? A 6 inch hole is needed. Let me know
Good luck
-
the pump motor is cooled when water rushes past it, which workes good in a 6in well caseing but not in a tank!
What works good is to sleeve the pump. Install a 3X4 inch fernco coupling at the top...
-
It appears that your shower base is made of concrete, if that is true with a hammer and a cold chisel bust up the concrete 4 to 6 inches around the drain!
Good luck
-
-
Did you check the areator
-
You can check your tank in this way: turn off the electric power to your water pump,then open some faucets, when all the pressure is off, ie; no water at faucets, using a tire gauge check the air...
-
1: turn off the water to your home.
2: remove handle.
3: remove large domed nut under handle.
4: remove delta ball,rubber seat's & springs.
5: if you find dirt and debris in...
-
There must be a tank and a pressure switch some place of some sort I have seen them in the well and even a buryed model!
The fact that the pump will run again after you turn the power off than on...
-
Sorry you will need cut the wall! Look at the bright side NO DAY IS COMPLETE UNTIL YOU USE A SAWSALL. Good Luck
-
If your softner is able to remove iron which I dout, ( try a sanitizer manufacted by water right) put the 1 mic filter after the softner as a finisher. Your softner should be able to do the bulk of...
-
Try rotating the cartridge 180 degrees
-
I lay down a piece of tar paper on the floor then mix up a 40 lb bag of mason mix. Mound it high in a circle around the drain hole, then set the shower into this mix. Good luck
-
I just purchused a 2005 subaru forester the key fobs are not available to me! We are unable to lock the doors because when we use the key to open the door the alarm goes off! Is there some way to...
-
For a solid steel flame rod, what type of meter do I need to test it? How is the meter hooked up? What setting should the meter be on? What should the reading be? Hope someone can help me
|