Ask Experts Questions for FREE Help !
Ask
    DelAffiliates's Avatar
    DelAffiliates Posts: 1, Reputation: 1
    New Member
     
    #1

    Sep 23, 2007, 03:38 PM
    Basement Remodeling w/Metal Studs - Vapor Barrier?
    I am attempting to refinish a large portion of my basement and have gotten recommendations to use metal studs from a friend, but two estimates from contractors who recommend wood (treated where in contact with concrete floor). I have been advised that with wood that I can frame sections and install a plastic vapor barrier to the back of each section prior to nailing them up. But, if I use metal, can I still install a vapor barrier? Can framing with metal studs be done in sections, similar to wood? Have I been given the correct advise on framing in sections? Any help would be gratefully appreciated.
    glavine's Avatar
    glavine Posts: 895, Reputation: 87
    Senior Member
     
    #2

    Sep 24, 2007, 03:15 AM
    I would say stick with wood for this project. Simply it will be easier for you.
    Rarely do we use metal unless it's a commercial job, this also complicates installing insulation and the vapor barrier if you go to metal for simple fastning reasons.
    Here's what to do. Use a treated bottom plate, the rest can be regular wood, you need to keep the framing an 1" off the wall, after you've framed it, the insulation is next , use r 13 or r 15, for the walls, your ceiling is most likely already insulated from the first story floor joist, next is the vapor barrier. Use a 4mil platic and staple this with a slap stapler is best making sure the plastic is covering the whole frame, where you have outlets just cut the out the plastic in those areas only. Next is sheetrock or whatever wall covering you want,
    One more thing its always best to seal the block walls before you do any of this, a good product to use is dryloc, get it from Lowe's or any paint store should sale this

    As for you other question, you didn't get bad advise you just got different advise , you will have more people stirr you toward a wood frame than metal, metal is much harder to work with unless you've had experience with it, good luck

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Vapor barrier in Bathroom [ 7 Answers ]

I am doing a bathroom remodel in my Central PA home. I have heard several different opinions on how to install a vapor barrier. I was told by one person that I should install unfaced insulation on all exterior walls and then install a 4 mil poly vapor barrier. After that, I should install green...

Shower stall vapor barrier [ 3 Answers ]

I'm building a new tiled shower stall with cement board backer. I've read that a vapor barrier should be placed over the wall studs before the board is installed, because the tile/cement board combination is not waterproof. We have an acrylic shower receptor, the directions for which also...

Metal studs vs. Wood studs [ 2 Answers ]

Can metal studs be used in a basement setting where there is no water problem?

When do I trim the vapor barrier in my remode of tube/shower [ 1 Answers ]

Hi, I am adding a shower to an already existing tube in a bathroom. I have removed everything down to the studs around the tube and am ready to put up my 4 mil polyethyline sheeting for a moisture/vapor barrier. I know that I need to put up 1/2 inch cement backer board next (following the...

Using Wood Studs with Metal Studs [ 1 Answers ]

I am in the process of adding a guest room and bath in my basement. The currect wall studs are metal. I have never worked with metal stud before therefore I am wondering if I should continue with metal or can I use wood as well. The current studs look like they are 24 oc. I have to frame in a...


View more questions Search