Ask Experts Questions for FREE Help !
Ask
    dhart1268's Avatar
    dhart1268 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 19, 2008, 05:21 PM
    Wiring a Honeywell Focus Pro 6000
    I have a Carrier Heat Pump (about 5 years old) that had a non-programmable White Rodgers thermostat 1F59-11. The configuration of wires for the old thermostat are as follows:

    C = blue wire
    G= green wire
    R = red wire
    O = orange wire
    W= white wire
    Y = yellow wire
    L = empty
    B = empty

    The new thermostat is a programmable Honeywell Focus Pro 6000 (universal)

    The designation for wires are as follows: I connected the wires as indicated

    L = left empty
    E = left empty
    AUX = white wire
    G = green wire
    O/B = orange wire
    C =blue wire
    Y = yellow wire
    R = red wire with jumper left in to Rc
    Rc = jumper left in from R

    I have connected the wires as shown above and get only the fan (auto or on) and the thermostat will say "heat on" but the outside unit never engages and no heat is produced. When I put back the original thermostat, all works fine again. I really question the position of the white wire (I have tried it in other locations). Any help would be appreciated very much.
    sandy123's Avatar
    sandy123 Posts: 2, Reputation: 1
    New Member
    		  
    #2

    Feb 18, 2008, 03:58 PM
    Ihave a honbeywellpro6000 6220,my wiring is as follow
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Honeywell wiring [ 1 Answers ]

My heater wire was cut and i wrapped it with electrical tape but after a time the wire gets hot and melts the tape, so i found another cord like it but i forgot which wire hooked to what except the ground wire now the heater light comes on but no heat is there somewhere i can get a look at the...

Honeywell wiring different from old thermostat wiring [ 2 Answers ]

I purchased a non-programmable digital thermostat to replace an analog thermostat with wiring red, white yellow and black. How do I match the wiring? HELP!!

Wiring for Honeywell RHT6300B [ 5 Answers ]

Hi all, I've been reading up on the various past posts on "wiring for a Honeywell RTH6300B", but unfortunately none of them seem to answer my exact problem. I live in a condo which had an old mercury based Honeywell thermostat. We removed it and there were 6 wires: Red, Yellow, Green, White,...

Replacing Honeywell T8411R with Honeywell RTH7500 - wiring problems [ 1 Answers ]

I need help getting my new, programmable thermostat to work. I currently have a dual-stage Heat Pump and A/C unit that works fine. The current thermostat is the Honeywell T8411R. I don't know the number for the subbase, but it's the one that came with the thermostat. The current (operational)...

View more questions Search