Why has my question had 56 views and no answers :( Am I supposed to be paying someone? I thought this was free. Help. Below is my question: I don't think my ignitor has a flame sensor, but it may be incorporated. It is a round ignitor. White on the bottom with a black spiral heating...

My Whirlpool washer model# LSR9434PQ0 will just hum when you try and start a wash cycle. If you rotate the timer to a spin cycle, it will work fine. I've looked at all of the wire harnesses and connections and there is no sign of a surge burn or a short. Any help would be great. I'm in the...

Last spring my furnace stopped working. I got new digital thermostat, air worked fine (didn't check heat... duh!). Last month I turned furnace on, it ran 1 cycle, then stopped. I fiddled with thermosat and popped of furnace covers and fiddled, and it kicked on again 1 cycle, then stopped again. ...

My heater has a hot surface ignitor. Ignitor kicks on - gas kicks on - gas lights - quickly goes out. Pulled wires on vacuum switch and put back. Works now - ignitor kicks on - gas kicks on - gas lights - quickly goes out - gas kicks back on quickly and stays lit. Is something wrong? ...

Heater doesn't kick on below 70 degrees. When it does kick on with thermostat set higher than 70 it will turn on run and then blow. (Pilot light works) Doesn't blow as long as it should then shuts off and idles (runs) again. Had a certified furnace repair person look at it. The limit switch was...