Check out some similar questions!
Amana furnace short cycling
[ 2 Answers ]
The induction motor comes on then the heat it's stay's on for two mines then cut off it short cycling all nights. Is this a bad pressue switch ,or abad board
Bryant furnace short cycling
[ 4 Answers ]
I have a Bryant 80 furnace , had the ignitor replaced in November. Since then the furnace will power up, ignitor and burners will go and then when the blower turns on the burners go out, the blower will go for about 90 seconds and then shut down. It will do this repeatedly sometimes as many as 30...
Short cycling furnace
[ 0 Answers ]
Hello Again, Thank you for the previous help suggestions. The last suggestion I received mentioned the possibility of a defective limit switch. I replaced the switch but that did not solve the problem. However, I did received a fault LED, "defect or flaw in gas flow". I checked my line,...
Older gas furnace is short cycling
[ 32 Answers ]
I have an older Sears "Fifteen" horizontal gas furnace (#867767840) located in the crawl space. Recently it has been short cycling, meaning it starts a normal cycle, runs for approximately 1 minute, stops for several minutes, then starts another 1 minute cycle. This repeats until the set...
Furnace Keeps Short-Cycling
[ 1 Answers ]
I have a Trane XL80 (Model #TUD060A936A0) that has been converted to a White-Rodgers (Model #50E47-060). When the thermostat calls for heat, the furnace short cycles until it is manually shut off. There is no indicator light on this unit to tell me what the problem may be. What else could... View more questions Search
Add your answer here.
|