Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Trane XL80 Can't Maintain Flame
[ 4 Answers ]
I have a Trane XL80 furnace. Basically, when it receives a call for heat, it ignites but cannot maintain the flame. As soon as the flame ignites (or within 10 seconds), it cuts off the gas flow and starts the ignition process again. It does this until the furnace locks out. Sometimes (probably 10%...
Trane xe 90 flame sensor or what
[ 3 Answers ]
I just moved in and furnace ignites for about 15 seconds then goes out. I've researched everything I can. Even found the orange wire for the press. Switch had "fallen" off and thought it might have been the whole problem, but still the same thing. From what I found so far I believe it has to be...
Flame sensor
[ 1 Answers ]
I have a York Diamond 80 upflow furnace. I think my flame sensor is bad. I checked my wire to the sensor with my meter ( I just completed classes in HVAC) and got 90 on the volts. Just wanted to make sure I am replacing the right part. The flame kicks on and goes out about 5-10 seconds later.
Flame Sensor
[ 5 Answers ]
How can I replace a flame sensor in a Trane heating unit?
Flame sensor questions
[ 3 Answers ]
I have a Goodman gmp125-4 gas furnace. I've been having all sorts of problems recently. I've fixed most of them, but the last problem I had was a code 5 "false flame sensed". The chart inside the door said the most likely problem was a stuck gas valve. I assume this is the problem if the fire... View more questions Search
|