Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Honeywell RTH3100c Wiring Question
[ 1 Answers ]
I have a Goodman 5 ton 13 seer heat pump. We have a pre-existing heating unit (electric) that is to be used for just Emergency heat. I connected all the wires, but there was a question that came up. The manual said that if the old thermostat had w1, w2 and why wires, I need to contact a heating...
Heat pump question
[ 1 Answers ]
I am a new homeowner and we have a lennox heat pump unit. It has been very hot here recently averaging about 90+ and I have noticed that during the day my heat pump seems to run almost continuously with the tstat set at 74. It will cut off once and a while but its usually only for about 5-10...
Wiring a replacement Honeywell Thermostat
[ 1 Answers ]
I purchased a Honeywell Vision 5-1-1 Day programmable thermostat to replace a Lennox thermostat (51H4301). This is an all electric heat pump type unit (Lennox HP 21-511-5P). According to the Honeywell manual, if the old thermostat has wires W1, Y1 and W2, some system modification is required. Call...
Honeywell rth6300B for Heat Pump?
[ 0 Answers ]
Can the Honeywell RTH6300B programmable thermostat be used on a carrier heat pump 38ycb o36300 model? The compatibility chart lists heatpump but a question that it not compatible with a heat pump with auxiliary heat... I do not know if my unit has this... thanks for your help and advice
Old honeywell thermostat with clock - wiring question
[ 4 Answers ]
I'm replacing an old honeywell thermostat with a new digital. The old one has the standard two wires - R and Wh, but then it has two C wires. I think they just provide power for the clock, and I'm wondering if I can just close off that circuit. The clock has two metal brush connections that... View more questions Search
|