Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
NO HEAT! Janitrol heat pump and AC system. Changing to Lux Thermostat. Wiring issue.
[ 11 Answers ]
I have a Janitrol A/C and heat pump system. I replaced the thermostat with a Lux T9000LC The A/C works fine, but the heater does not. I have it wired as follows: G - Green Y - Yellow W - White RH - Pink B -
Electric Heat-Pump-No heat
[ 2 Answers ]
I had a wall-mounted unit installed in a room in may of this summer. In the middle of the night the heat shut off and has not come back on since. It is an Amana, electric heat with heat pump unit. The cooling works, the heating setting does not blow air at all. When I remove the cover it says...
Condensing Unit Frozen and Running Constantly
[ 6 Answers ]
For a couple weeks now I've noticed that the pipes leading from one of the outside condensing units had ice around them. This morning I opened up the unit and found ice around the compressor, too. Another thing that I've been noticing is that the fan will run all the time even if I turn off the...
Strange Breaker problems with Heat pump and AC unit
[ 1 Answers ]
Recently we have been having strange issues with our breakers. :confused: Typically if we have more than 2 appliances running in the kitchen, the GFI outlets will pop the breaker. We just reset it, and try not to use too many things at once. This is fine. :rolleyes: But... yesterday, I...
New condensing unit problem
[ 1 Answers ]
I installed a new condensing unit and put freon in the unit, I am getting the same pressure on the high and low sides of the gauges. This leads me to believe that there is a compressor problem or that I put too much gas in it. I am reading 150 psi on the high side and the gauge is pinned on the low... View more questions Search
|