 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Bryant furnace problems
Furnace is 5 yrs old, have reset it , thermostat goes blank, blower continues to blow but only cold air. When try to restart it, it may run for 5 minutes, then goes off and blows cold air again. Replaced fuse, shut off circuit breaker and restarted, but continues to not run. Filter is clean, no debri anywhere. It runs on propane. The flashes look like 33 but not sure. Any suggestions?
|
||||
Check out some similar questions!
I have a Bryant Plus 90t Furnace installed in 2007 and the Flame Sensor keeps getting corroded it had to be cleaned three times since installed in 2007 I have no heat until it is cleaned. My question is why does it keep getting corroded. Thank You Nick [email protected]
Hi, I have a Bryant 93% efficient furnace (2 stage motor) that is about 7 years old... the problem I have been having is that the furance won't start... the thermostat is set at 70 and the current temp in the house is 64! Whenever you turn the furnace on, the blower fan motor hesitates ~ you can...
I have a Bryant 80 furnace. As louck would have it the blower motor just went and of course it is within a year of the warranty expriing. Does this seem right?
I have a Bryant gas furnace Model Plus 90i 355MAV. When it runs in high heat mode for several minutes it makes this thumping sound that seems to be coming from the blower area, after a couple of seconds the furnace shuts down. Any Help? Unit is about 6 years old
Hello everyone, I have a Bryant 80v furnace. Everything works fine till it is time for the blower fan to come on. I have opened it up, and the fan wheel turns freely. Checked the fuse on the circuit board no problems there. I been doing some reading about it all day long. The furance lights and...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
