Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Furnace Limit Switch
[ 15 Answers ]
I've raised this issue in other forums. I have a high efficiency furnace that has worked flawlessly for the last four years (the house was built in 2000). This year we had to have the circuit board replaced. After that there was a problem with the blower, i.e. it wasn't shutting down after the...
Bypass limit switch on amercan standard freedom 90
[ 1 Answers ]
American Standard freedom 90 blows cold and red light flashes 6 times. Does this mean the igniter has gone out?
Limit switch on furnace
[ 1 Answers ]
The blower is running but not putting out any heat
Furnace Limit Switch
[ 6 Answers ]
I have Bryant upright furnace (Model 394GAW048100). Furnce runs fine for the first 4 or minutes in a cycle and then gas is cut automatically while the pilot is still on. After a few seconds, the gas again comes on and Furnace works fine for about 30 seconds, again gas is cut and so on. I changed...
? Safe to bypass vacuum switch to test furnace ignition?
[ 3 Answers ]
I have two Amana 80 SSE IIO units. One just stopped igniting. The trouble indicator light was blinking 2x to indicate the vacuum switch was stuck closed. I made sure the tube was clear, and applied suction to the tube to and could hear the switch activate. The trouble light shows clear now.... View more questions Search
|