Ask Experts Questions for FREE Help !
Ask
    engine01's Avatar
    engine01 Posts: 2, Reputation: 1
    New Member
     
    #1

    Jan 31, 2009, 09:46 AM
    Changing pilot module
    Can't seem to get honeywell s8610u replacement module to work. Original module was S8600. Installed as called for in instructions and will not ignite, but gas is present.Checked grounds etc. all OK. Removed module off second unit and installed on broken unit and it works good.
    greghvacguy's Avatar
    greghvacguy Posts: 45, Reputation: 2
    Junior Member
     
    #2

    Jan 31, 2009, 10:35 AM

    Need more info. Furnace model and make.
    Info on old moudel what wire went to what and where did you put them to new one.what s8610u**** did you get.
    engine01's Avatar
    engine01 Posts: 2, Reputation: 1
    New Member
     
    #3

    Jan 31, 2009, 12:20 PM

    Raypak M#W2-o624c-
    S8610U3009- replacing S8600H1005.
    Replaced wire for wire on new as they were on old. Also tryied putting on twh instaed of 24v supply as book asked.Still no ignition.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Does putting gas hot water heater dial on PILOT put pilot light out? [ 5 Answers ]

My gas hot water heater dial has OFF to the left, PILOT in the middle and ON to the right. If we are going away and want to not have the water heated can we just turn the dial to PILOT and the flame will stay lit but just won't heat the water or does the flame go out completely and then PILOT would...

Pilot light won't stay on.already tried changing thermocouple [ 7 Answers ]

I realized 2 weeks ago that there was cool air coming out of my vents when my heat was on. I then figured out that the pilot light would not stay on. I changed the thermo couple and it seemed fine. It would stay lite and the heat was working. Last night I truned the heat on and the same problem...

Lennox Ignition Pilot Control Module [ 3 Answers ]

My problem with my Lennox furnace (model G23Q-3/4-100-2) is blowing cool air, and only occasionally heat was diagnosed as needing a Universal Pilot Module, part #53L9001 also known as 53L90. Question, if we purchase the part how difficult is the installation?

Replacing intermittent pilot control module [ 1 Answers ]

I have a 22 old Janitrol (goodman) furnace and my furnace guy, besides trying to sell me a new furnace, says the intermittent pilot control module need replaced as it sounds like it's not working properly (bouncing relay). My problem is he wants to charge an arm an a leg to replace it and I found...

Pilot light stays on but pilot switch keeps resetting [ 5 Answers ]

I have a baso L62AA-5 pilot switch and it used to keep resetting. I would hold the switch down for a good minute and the gas lights, but after a half an hour or so it would go back to its reset position. The standing pilot light was always on and never a problem. After a few days of manually...


View more questions Search