Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Goodman furnace GMNT080-4 furnace runs good for a while then has to be manually reset
[ 5 Answers ]
I have a Goodman GMNT080-4 (90%). I'm having the same problem As Streatherg did back in the Nov 2006 question. I reviewed his article and tried Every thing on there but seems to be doing the same thing. The furnace kicks on for about an hour then locks out and has to be manually reset threw...
Goodman Furnace
[ 4 Answers ]
I have a two year old high efficiency Goodman furnace that seems to have problems from time to time. The strange thing is that my son-in-law had his furnace installed about the same time and he has the same problem. We have our thermostat programmed for 62 during the night and at 6:00 am it goes...
Goodman furnace
[ 1 Answers ]
Furnace flame will stay on for 5 seconds and shut off. Led light on circuit board flashes once after it completes cycle. 1 flash indicates the following possible problems: Gas flow... Gas pressure... flame sensor... as a result, everything seems to be working normal. However, I did replace the...
Goodman furnace
[ 1 Answers ]
I would like more info about Goodman furnaces. I just had a man look at my old furnace and give me a bid of $1,450.00 to take out the old one and install a Goodman 80% and bring the old piping up to code. Thanks... jorjee
Goodman Furnace
[ 3 Answers ]
I have a six year old Goodman Furnace that will not kick on or even begin the start up cycle. Last year I replaced the ignitor and checked it out today and looks fine. Any obvious place I should start to determine the issue? Thanks Jim View more questions Search
|