Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Bad Furnace Control Board?
[ 6 Answers ]
I have a Carrier 58PAV that intermittently aborts or sometimes clicks on and off at the draft blower stage. I found out I can move the control board (HK42FZ007) when the blower motor clicks off, and it clicks and comes right back on. If I hold it just right, the furnace starts and if I manage to...
Power to furnace control board but stops there
[ 3 Answers ]
Hi I was given a Nordyne KG6RA gas furnace. After installing, I turned on and there was a low hum when the power got to it. I held the door switch closed so I could see. After a few seconds there was a spark and then blue smoke and everything went dead. I could not see where the smoke came...
Wiring question for new blower control board
[ 1 Answers ]
Just bought the Lennox blower control board replacement kit - 31M73 I'm stuck on wiring the transformer--- The five wires coming out of the transformer going to the old board are - Yellow - common Blue - 24 vac Orange-L2 XFMER Primary Black - L1 XFMER Primary Red - PARK
Powering the G terminal on my furnace control board
[ 1 Answers ]
Hi! My furnace's control board recently blew and the repair guy replaced it with a different kind. Aparently the new board requires a wire from the thermostat to the G terminal to work the A/C fan, and the old one didn't. The repair guy would need to make another trip for this repair. I am...
Furnace blower
[ 1 Answers ]
I have a older home with a older furnace. I started it up this fall and the blower continues to run after the house has warmed and the themostat has turned off. The blower runs and runs, blowing cool air. To stop it I have to turn off the main switch to the furnace. What do you think the... View more questions Search
|